hvalev/bh1750mqtt-homeassistant repository overview

⁠bh1750 illuminance sensor in a docker container

This docker container enables you to use the BH1750 illuminance sensor on a GPIO enabled device such as raspberry pi. This container can communicate with an MQTT broker and relay the sensors' values in addition to integrating with home assistants' discovery⁠ protocol. Discovery will automatically detect the sensor and make it available for visualizations, automations, etc within your home assistant instance.

⁠How to run it

The following docker run command or docker-compose service will get you up and running with the minimal configuration. docker run --device=/dev/i2c-1:/dev/i2c-1 -e topic=zigbee2mqtt -e device_id=bh1750 -e broker=192.168.X.X hvalev/bh1750mqtt-homeassistant

version: "3.8"
services:
  bh1750mqtt:
    image: hvalev/bh1750mqtt-homeassistant
    container_name: bh1750mqtt
    devices:
      - /dev/i2c-1:/dev/i2c-1
    environment:
      - topic=zigbee2mqtt
      - device_id=bh1750
      - broker=192.168.X.X

/dev/i2c-1:/dev/i2c-1 is required to access the Inter-Integrated Circuit bus and communicate with your BH1750 sensor. If it doesn't work, you can try to run the container in privileged mode privileged:true.

⁠Parameters

The container offers the following configurable environment variables:

If you end up using log2file, make sure to add this volume in your docker run or docker-compose commands - ~/yourfolderpath:/log to be able to access the logs from your host os.

If you want to run this container to simply record values to files with no MQTT integration, you need to explicitly set mqtt_chatter to a blank string. In that case, you can also omit all MQTT related parameters from your docker run or compose configurations.

If you're using this container for multiple sensors on the same or different devices which, however, connect to the same mqtt network, you need to explicitly pick a unique device_id for each. Otherwise, identically named devices will boot each other off the network each time they transmit a reading.

I have noticed that using measure_high_res2 for sensor measurement mode sometimes produces 0 lux measurements. Some sort of filtering may be required if you opt for it.

⁠Connecting your sensor

There are multiple online resources on how to hook up your sensor. Be mindful that the pins your sensor is connected to influences the addr pin parameter above.

⁠Acknowledgements

The bh1750.py class has been shamelessly copied from the following gist⁠.